Beckett AF Manual de instrucciones

RESIDENTIAL BURNERSPotential for Fire, Smoke and Asphyxiation HazardsTo the Homeowner or Equipment Owner:Please read and carefully follow all instruct

10Burner ControlsGeniSys Model 7505 ControlWiringFigure 7 - 7505 Control FeaturesThermostat / Operating and Limit Control CompatibleWelded Relay Prote

11AFII Burner Manualthe igniter remains on for 10 additional seconds to ensure fl ame stability. Run: The fl ame is sustained until the call for heat i

12Figure 8a. – Interrupted ignition, valve-on delay only (no motor-off delay)Figure 8b. – Interrupted ignition, valve-on delay and motor-off delaySAFE

13AFII Burner ManualRECYCLE. If the fl ame is lost while the burner is fi ring, the control shuts down the burner, enters a 60 second recycle delay, and

14Start Up Burner and Set CombustionSet the thermostat substantially above room temperature.Close the line voltage switch to start the burner. If the

15AFII Burner ManualPerform Regular MaintenenanceThe following guidelines are provided for routine maintenance. Replace the oil supply line fi lter. Th

16Table 4 - Nozzle Flow Rate by SizeNozzle fl ow rate U. S. gallons per hour of No. 2 fuel oil when pump pressure (psig) is:Nozzle size (rated at 100 p

17AFII Burner ManualFigure 10a. HLX Air TubeSK9639Figure 11a. Electrode Settings-HLX Air Tube Combinations1-1/2”15/32”3/32”5/32”1/4”5/32”Nozzle face t

18HLX Firing RateStop ScrewAFII 85 AFII 100 AFII 1500 0.40-0.65 0.5-0.65 0.75-1.001 - 0.6-0.75 0.85-1.102 - 0.65-0.80 0.95-1.153 0.60-0.75 0.65-0.90 0

19AFII Burner ManualFor best performance specify genuine Beckett replacement partsItem Description Kit No.14 Housing ass’y: AFII 85 & 100

2

USA: P.O. Box 1289 ● Elyria, Ohio 44036Canada: R.W. Beckett Canada, Ltd. ● Unit #3, 430 Laird Road ● Guelph, Ontario N1G 3X7www.beckettcorp.comPart Nu

3AFII Burner ManualTo the Owner:Thank you for purchasing a Beckett burner for use with your heating appliance. Please pay attention to the Safety War

4General InformationSection: General InformationHazard Defi nitions Within the boundaries of the hazard warning, there will be information presented de

5AFII Burner ManualInspect/Prepare Installation SiteClearances to Burner and ApplianceProvide space around burner and appliance for ease of service an

6HB 6 slotHC 9 slotHD 6 slotHE 9 slotAny accumulation of soot or debris in chimney offsets should be removedAny obstructions such as a protruding join

7AFII Burner Manualthe burner or provide a sealed enclosure for the burner and supply it with its own combustion air supply.Direct/Sidewall Venting Ap

8On the outside of the home use a 90° elbow pointed downward with a 1/4” mesh screen over its opening. The air inlet elbow must be located above the

9AFII Burner ManualFigure 6. – Mounting Burner in Appliance3 GPH150-200PSI 3450 RPM4GPHGPH100-150100-150PSIPSI34503450RPMRPMBY-PASSINLETA2EA-6520A2EA-